Setting up a PS4 Controller with DS4Windows

[Matrix]

Matrix Staff last edited by H3X1C

Introduction

This guide will cover using a controller on Plutonium support titles.
Note: MW3 does not have controller support for the menus, only in-game play.
Please ensure you have steam controller configuration support disabled otherwise controller support will not work!

Xbox Controllers

Xbox 360 and Xbox One controllers are plug and play on both MW3 and BO2! Simply connect the controllers and they will start working, if you experience issues confirm in the controls menu that gamepad / controller is enabled.

Playstation Controllers

PS4 Controllers require a bit more of setup to use. The first thing you will need to download is DS4Windows. The Download button will take you to the GitHub releases page, where you should download the .zip for the most recent release

Open the zip file you just downloaded and you will see two exe files

You can put these files anywhere on your computer but I would recommend something like Documents/DS4Windows/. After you have extracted these two files to a folder of your choosing you should run the DS4Updater exe just to be sure there are no new releases

Next you need to open the DS4Windows.exe and you should see two windows pop up. If you do not see the Welcome to DS4Windows window where you install the DS4Driver, you can click the Settings tab in the main window and click the Controller/Driver Setup link. NOTE You will ONLY need to do this if you have not previously installed DS4Windows

Click the Step 1: Install the DS4 Driver button in the second window and let it install. After this is finished you should see a Virtual Bus Driver folder inside the directory that the DS4Windows.exe file is located. If not, you may need to run DS4Windows as admin.

After the install is complete you will need to restart your PC and when it comes back up, re-launch the DS4Windows.exe application. This time you should only see the main window. At this point click on the Controllers tab and plug in your controller. You should see an ID show up meaning your controller is being recognized. NOTE The color at the end is a custom color you can put on the light bar. Mine being yellow and yours being blue/red/green does not matter.

At this point you are good to go and can launch Pluto IW5 and have controller support without any configs! Remember, you must leave DS4Windows open and running. If you close the application, your controller will stop working.

A good way to verify that your controller is connected and the game recognizes it is to open the console (~ key) and type "gpads_present" on IW5. You will see a value of 1 if your controller is working

[Yankez]

Yankez last edited by

This post is deleted!

[Ishxxl]

Ishxxl last edited by @ Yankez

This post is deleted!

[Karp]

Karp last edited by @ Yankez

This post is deleted!

[SockaSouka]

SockaSouka last edited by

This post is deleted!